Light up the ground under your crawler to help you choose the right line!
These rock lights are made from sealed LED strips that will run from 3S power (~12 volts). A light controller lets you operate the rock lights with a two position channel.
Attach the lights to your rig with the already applied 3M adhesive. My preference would be to use the original adhesive to get the light positioned where you want, then make sure they stay in place with a bit of Shoo Goo or Goop etc.
Notes from the manufacturer: To try and keep this item as affordable as possible, there is some work involved for the installer. Connectors for the lights and power have been omitted. Tie all the red wires from the lights together and to the red wire of the light controller. Tie all the black wires from the lights together and to the white wire of the light controller. Plug the receiver plug into a two position channel. Make the connection to a 3S battery to the red and black power wires. My suggestion would be to solder them to the battery connector on your ESC.
Maximum Switched Current: 10A
Go to your transmitter and use your Channel 3 switch. If it is a two position channel, flip the switch to turn the lights on and off. If it is a three position third channel, the two outer positions will give you on/off. If you have a linear third channel, move the control from one end to the other. You will notice the output switching somewhere near the center of the control's motion.
|