Return to Gear Head RC 4-Link Truss for Axial AX10 or SCX10 (1) - DISCONTINUED
Sort By::
Page of 3
Previous   


  0 of 0 people found the following review helpful:
 
5 of 5 Review February 26, 2014
Reviewer: David Cyr from Cortland, IL United States  
Great product. Fast delivery

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Gear Head 4-Link Truss for Axial January 20, 2014
Reviewer: Jeremy Carter from Salem, UT United States  
Worked awesome & fit perfect...I'm using it so I can run a pan hard bar with a 4 link set up :) I also noticed how well it worked with my CMS now my servo horn doesn't hit my 4-Link truss :) RPP you really do ROCK your fast shipping and customer service is the BEST...

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 truss August 14, 2013
Reviewer: Andrew from CO, United States  
Great for SCX10 wrangler or honcho, you do have to file the rod ends a little to fit I used 600 wet grit sandpaper.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 They Work Great February 3, 2013
Reviewer: Brad West from Redwood City, CA United States  
I bought these for both my SCX10 and Honcho. Very Simple to install. These clean up all the unwanted forward and backwards axle rocking from the stock 3 link and make the rear end nice and solid. For upper links, I used 91mm links for the SCX10, 106mm for the Honcho. This did change the pinion angle, but made it IMO better. My only complaint is I did have to file the ball joint a tad to get it installed. The width to put the link in was a bit tight. Overall really happy with this.

Was this review helpful to you?

   
  Previous   

Our Friends Say...