Features: CNC Machined Hardened Steel Scale design Fully assembled Precision splines Up to 50 degrees operating angle Compatible with Axial M4 screw shaft (AX31045) Suitable for front and rear of Axial SCX10 & SCX10 II RTR Suitable for front of Axial RR10 Includes M4 screw pins (SSD00237) Suitable for rear of 312mm wheelbase TRX-4 (Bronco & Kit) Suitable for front of Wraith 1.9
Specification: Fits 5mm diameter shafts M4 set screw Weight: 53g Min length (pin to pin): 100mm Max length (pin to pin): 120mm
What's Included: 1 X Steel Driveshaft for SCX10/RR10 front 2 X M4 Driveshaft pins
First off I’m not pushing crazy power through these shafts, just a HH pro brushed motor and deep gearing on 3s. But they look great installed, and so far are holding up well and show no wear after a few long runs. I hope they stay tight.
Was this review helpful to you?
Richard
September 6, 2020
Nice part
SSD drive shaft is well made no issues with install. So far has held up to a 3500 kv motor and a three cell lipo!
Was this review helpful to you?
Thomas Murrow from Brownsville, TX United States
June 15, 2020
Quality good. Like the looks. Front and rear same length 100/120. Non-re-buildable has not been an issue. just keep joints lubed with dry lube.
