Home > Cars & Trucks > Short Course >

Traxxas Chassis Conversion Kit Low CG Slash 4x4

Traxxas Chassis Conversion Kit Low CG Slash 4x4

More Photos:

RPP Price: $75.00

Note: Coupon discounts not allowed
by manufacturer

 In Stock!

Availability:: Ships to USA ONLY
Part Number: TRA7421

Slash® 4X4 Low-CG (Low Center of Gravity) Conversion Kit
Low-CG Chassis Conversion Kit (#7421) for Slash 4X4
Everything to convert your Slash 4X4
Low-CG Chassis Conversion Kit (#7421) for Slash 4X4 (#6808) (kit pieces)
Performance-proven by the Slash 4X4 Ultimate and 1/10 Rally, the Traxxas Low-CG chassis is now available as a complete conversion kit for Slash 4X4. No matter where you want to race, on the track or off, you will experience superior handling and faster corner speed. The conversion kit includes all the parts and hardware required to convert one Slash 4X4 to the Low-CG configuration.
Performance Optimized
Low-CG Chassis Conversion Kit (#7421) for Slash 4X4 (#6808) (assembled)
The Low-CG chassis holds the battery* and electronics* as deep in the chassis as possible to position weight low in the chassis. To prevent flex under load, the chassis is reinforced by integrated ribs that form a ridged triangulated structure. Underneath, the chassis is ultra-smooth to reduce drag and prevent snags whether you're blasting through whoops on the track or blazing trails in your backyard. The low-CG design dramatically increases corner speed and stability no matter where you drive.
Integrated Personal Transponder Mount
Transponder for Low-CG Chassis (#7421)
If your Slash 4X4 is destined for the track, the Low-CG chassis is ready to accept your personal transponder. Bosses integrated into the chassis make it easy to mount the transponder with two screws, no tape required. And of course, the transponder mounts up front, so it gets to the finish line faster!
Complete kit, no additional parts required
Lowers chassis one inch
Over 50% lower battery position
Low center of gravity enhances handling and increases cornering speed
Integrated transponder mount
Genuine Traxxas quality and precision
7421 Low-CG chassis conversion kit for Slash 4X4 includes:
Nerf bars (2)
Front bulkhead
Rear bulkhead
Motor mount
Motor plate
Battery hold-down
Front and rear hold-down retainers
Servo horn
Steering linkage
Waterproof receiver box with o-ring seal
Gear cover
Wire retainer
Complete installation hardware set

Average Customer Review: Average Customer Review: 4.5 of 5 4.5 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
4 of 5 LCG Slash 4x4 June 10, 2015
Reviewer: David Floyd from salem, OR United States  
This kit was a little more money than I wanted to spend, but was only place that had them in stock when i ordered.

Was this review helpful to you?

  1 of 2 people found the following review helpful:
5 of 5 Traxxas Chassis Conversion Kit, Low CG, Slash 4x4 April 17, 2013
Reviewer: Delage Joël from Trois Rivières , QC Canada  
Wowwwww ,Just a amazing kit that you will need without hesitation TRA 7421 is the best way to Upgrade your Slash 4x4 and win the race !!! Super Fast shipping, Perfect service i will by again and again from RPP.

Was this review helpful to you?

Browse for more products in the same category as this item:

Cars & Trucks > Short Course
Cars & Trucks > Short Course > Short Course Parts > Traxxas Slash 4x4
Cars & Trucks > Short Course > Short Course Parts
Cars & Trucks

Our Friends Say...