Titanium Hardware Kit – Vanquish Products F10 Portal Rear Axle
This kit includes lightweight, high-strength titanium screws to replace the standard hardware used when assembling the F10 Portal Rear Axle. Titanium offers an excellent strength-to-weight ratio and corrosion resistance—ideal for performance-focused builds.
Note: M3 nylock nut is not included. Titanium nylocks are not recommended for use with titanium screws. See installation instructions below for details.
Installation: Follow the instructions below to prevent damage to components or hardware.
Includes:
12x M2.5x10mm Caphead
4x M3x10mm Buttonhead
2x M3x15mm Buttonhead
2x M3x20mm Buttonhead
1x M3x35mm Buttonhead
Installation Notice for Titanium Hardware:
Titanium fasteners require specific installation practices to prevent damage or failure.
When installing into plastic:
Do not use lubricant.
Hand-tighten only—do not overtighten, as titanium threads can easily strip plastic.
Avoid using impact drivers.
When installing into metal or threaded inserts:
Always use anti-seize lubricant (nickel- or moly-based) to prevent thread galling. e.g. Permatex 77124
Do not pair titanium screws with titanium nylock nuts. Use stainless steel or aluminum nylock nuts instead.
Torque values should be reduced by 20–30% compared to steel fasteners.
Ensure threads are clean and lubricated before installation.
Avoid dry fitting and use hand tools for final torque.
Failure to follow these guidelines may result in damaged threads or seized fasteners.
